Body:  Sutphen Stainless Steel Rescue Body

Driver Side
Compt. A:  1st Compt. ahead of wheel well
                  - 29"H x 18"W x 24"D
Compt. B:  2nd Compt. ahead of wheel well
                 (Compt. for Manual Ladder controls)     Compt. C:  1st Compartment behind wheel well
                  - 46"H x 24"W x 26"D
Compt. D:  2nd Compartment behind wheel well
                 - 46"H x 47"W x 26"D
Compt. E:  (1) High Side Compartments
                 - 15"H x 32"W x 24"D
Passenger Side
Compt. F:  1st Compt. ahead of wheel well
                  - 46"H x 18"W x 25"D
Compt. G:  1st Compt. behind wheel well
                 - 25"H x 32"W x 26.5"D
Compt. H:  2nd Compt. behind wheel well
                 (Generator Storage)
Compt. I:  (2) High Side Compartments
                  - 34"H x 36"W x 25"D
Rear
Compt. J:  (1) Center Rear Compartment
                 - 16"H x 41"W x 46"D
 

Reduced - $350,000 (Was $400,000)

Driver Side           Only Equipment Listed In Specs. Goes With The Sale

Driver Side Compartments:

Passenger Side          Only Equipment Listed In Specs. Goes With The Sale

Sutphen 100’ Platform
Refurbishment List As Supplied By Sutphen

- inframe engine overhaul
- replace pump primer
- water tank
- remove old sway bars from frame
- replace all hydraulic hoses
- pull ladder apart, sand blast ladder beams, paint
- rebuild waterway
- replace ladder slide blocks
- replace ladder cables
- new treadplate on compartment tops
- new ground ladders and brackets
- pump test
- National Testing
- new front tires - T839 425-65R22.520PR  new rear tires - 11R22.5 14PR
- buff aluminum wheels
- change engine oil and filter
- change transmission fluid and filter
- 120 gallons hydraulic fluid
- install new treadplate under TT
- new front seat belts
- remove fold down seats on engine hood
- install tanker seats, jump seat area
- new cab upholstery
- new cab floor mat - front & rear
- dog house insulation
- new lug caps and centers
- four (4) new grab rails
- new air pack bracket, officer seat
- new hand held spot light
- ten (10) under body lights
- electric waterway valve & flow meter
- breathing air minder
- tail lights, new style
- LED ICC lights
- wire & install 6K generator
- two (2) cord reels, two (2) light boxes
- new jack interlock system
- intercom system
- breathing air bottle and regulator
- new treadplate running boards
- new treadplate turntable and fence
- four (4) cab steps
- Install new Q2B siren
- strobe lights, lower package
- new slide blocks in high hand rail
- paint truck & inside of cab
- yellow electric cable
- rebuild electric reel, brushes & holders
- lettering
- striping
- air dryer w/wiring harness
- new cab dash, repair wiring, repair/replace gauges as needed
- steering wheel
- new strobes on bottom of bucket
- turntable bolts - top & bottom
- remove all slide out trays from compartments
- new crosslay, treadplate box
- two (2), 1-1/2" crosslay valves and piping
- new front jack feet (steel)
- new cradle blocks
- 110 breaker box and wiring
- pull out step at pump panel
- new front fenderettes and rubber
- four (4) new near fenderettes
- replace some rub rail and clean remainder
- replace cab mirrors
- new heat exchanger for pump
- mud flaps - front & rear
- two (2) jack pads - plastic
- five (5) jack switches
- compartment door switches
- new tags and warning labels
- new truck battery and wiring as needed
- new light bar and installation
- Ziebart
- sandblast turntable
- muffler for generator and pipe
- compartment door rubber
- new cab door rubber
- repair bucket
- steam clean ladder
- steam clean turntable
- Gresen valve, rebuilt
- switches for hydraulic compartment
- breathing air reel
- breathing air hose
- sandblast hydraulic cylinder mounts, waterway beams
- new tail lights, compartment lights, compartment door switches & repair wiring